Our Builds
08/01/2020

ANOTHER STOCK 7.5T BEAVERTAIL FOR SALE THIS TIME A CANTER AND READY TO GO

Stock vehicle ready to drive away! fitted with full width ramps, 3 year body warranty, Crossrail Gold Standard. full specifications below

SPECIFICATION
o 7.5 Tonne low profile beavertail body.
o Battery and electro-hydraulic powerpack set up.
DONOR VEHICLE
o Fuso Canter 180 4300wb
o Prepared with bodybuilders electric module and drawbar electrics.
SUBFRAME
o Constructed from hollow box section.
o Lightweight pressed channel cross members.
HEADBOARD
o Full width steel frame to approximately 650mm high.
o In-filled with alloy plank.
o Grab handle to cab side of headboard.
o Ladder rack to cab height, in-filled with steel mesh.
MAIN DECK & DECKING
o Approx 6100mm x 2270mm (inclusive of double cranked beavertail approximately 1800mm)*.
o Spare wheel mounting moved to an alternative position if fitted.
o 18mm high grip laminate plywood floor throughout.
o Four pairs of deck mounted lashing rings along outer edge of body on the main deck.
o Two further pairs of deck mounted lashing rings along the beavertail.
o Cross members at 300mm centres.
o Tow bar and hitch with electrics
RAMPS
o Hydraulic 2.2m length, full width Double flip ramps, overlaid with HD mesh (upgrade).
o Operation via weather protected push button control under beavertail nearside.
o Manual swing down steady legs provide stability support when loading/unloading.
WINCH
o C2500EN electric winch mounted at the front of the deck as far forward as possible.
o Supplied with wander lead control.
o Protection framework each side of the unit.
o Radio remote kit for winch with back up wander lead control.
LIGHTS
o Stamped and installed to meet the latest European Whole Vehicle Type Approval regulations.
o Original truck lights used where possible.
o LED side markers and  reflectors supplied.
o LED amber ramp markers visible when ramps lowered.
o LED Worklamps (Rear facing onto body).
o Pair of LED quad flashes to front grill.
o Pair of LED quad flashes to rear.
MUDWINGS & GUARDS
o Mudguards and side-guards supplied and installed in accordance with Whole Vehicle Type Approval directives.
o Rear under-run protection to latest WVTA regulations.
PAINT
o All bodywork prior to painting is thoroughly cleaned.
o After final preparation, 2pack primer is applied followed by 2pack topcoat.
o Body painted black
OPTIONS INCLUDED
o Grab rail to nearside of headboard.
o Whole Vehicle Type Approval (WVTA).
o Rear Under-run protection as per latest WVTA legislation.
o Daken 800mm chassis mounted tool box in support frame with LED internal lighting.
o Twin strap and post edge protection.
o Crossrail / FORS compliance kit.

Make: Fuso

Model: Canter
GVW: 7,500kg
Wheelbase: 4,300mm
Chassis weight: 2,663kg
Finish weight: 3,960kg
Body: 1,297kg

Payload: 3,540kg